ausmini https://ausmini.com/forums/ |
|
Help with these holes in my block.. https://ausmini.com/forums/viewtopic.php?f=2&t=92575 |
Page 1 of 1 |
Author: | Budgiedagreat [ Sat May 07, 2016 4:43 pm ] |
Post subject: | Help with these holes in my block.. |
Just wondering what goes in these, engine came with nothing attached . ![]() Sent from my iPhone using Tapatalk |
Author: | justfanginaround [ Sat May 07, 2016 4:46 pm ] |
Post subject: | Re: Help with these holes in my block.. |
oil pressure sender = little one. Oil pipe + banjo bolt to oil filter housing= big one with red cap |
Author: | Budgiedagreat [ Sat May 07, 2016 5:01 pm ] |
Post subject: | Re: Help with these holes in my block.. |
Awesome cheers!! Sent from my iPhone using Tapatalk |
Author: | ALPINE MOKE [ Sun May 08, 2016 8:38 am ] |
Post subject: | Re: Help with these holes in my block.. |
It looks like a south african engine, it is where the oil filter screws into the block. pull the plug out to reveal a internal screw thread, it is missing the nipple that the oil filter screws on to. |
Author: | Budgiedagreat [ Sun May 08, 2016 9:06 am ] |
Post subject: | Re: Help with these holes in my block.. |
It's a metro turbo block oil filter is on the far right. Sent from my iPhone using Tapatalk |
Author: | ALPINE MOKE [ Sun May 08, 2016 10:31 am ] |
Post subject: | Re: Help with these holes in my block.. |
Ok then the small hole is the oil pressure pipe to the oil pressure gauge. |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |