| ausmini https://ausmini.com/forums/ |
|
| GF 266 cam versus Wade 104 https://ausmini.com/forums/viewtopic.php?f=2&t=91227 |
Page 1 of 1 |
| Author: | Minicooper4me [ Mon Dec 07, 2015 9:25 pm ] |
| Post subject: | GF 266 cam versus Wade 104 |
Can someone out there give me the specs on a GF 266 cam as compared with a Wade 104. Much appreciated. |
|
| Author: | drmini in aust [ Mon Dec 07, 2015 9:29 pm ] |
| Post subject: | Re: GF 266 cam versus Wade 104 |
Tighe 104 is same as a Wade 104. http://tighecams.com.au/cars.htm click on BMC A series I found the 104's valve lift was less than stated. It was only around .318" with stock 1098 rockers. So I put 1.5s on it. Cam wasn't brand new, had done 10,000km but still looked new. Graham's 266SS has less advertised duration, but much more @ .050" lift. I'm sure he'll put some numbers up, soonish. 
|
|
| Author: | Minicooper4me [ Tue Dec 08, 2015 8:37 am ] |
| Post subject: | Re: GF 266 cam versus Wade 104 |
Thanks Doc, much appreciated. And yes, GR is on to it with an email. I intend to spend quite a few bucks on the motor rebuild. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|