Get Hi-lows.
For a sec I thought this thread c,ould be another spammer one!
| ausmini https://ausmini.com/forums/ |
|
| larger rubber cone https://ausmini.com/forums/viewtopic.php?f=2&t=30944 |
Page 1 of 1 |
| Author: | buztoy [ Sun Apr 22, 2007 8:44 pm ] |
| Post subject: | larger rubber cone |
hey can you buy a larger rubber cone for the suspention, i only need to raise it 20 mm, exhaust is 85mm from the ground and the edge of the tyre is 12mm from the gaurd, |
|
| Author: | Harley [ Sun Apr 22, 2007 8:48 pm ] |
| Post subject: | |
Get Hi-lows.
For a sec I thought this thread c,ould be another spammer one!
|
|
| Author: | Morris 1100 [ Sun Apr 22, 2007 9:02 pm ] |
| Post subject: | |
The factory way of raising the car is to fit a washer between the cone and the knuckle joint. The simple way is to fit Hi-lows. The cheap way is to use a washer. 
|
|
| Author: | Harley [ Sun Apr 22, 2007 9:06 pm ] |
| Post subject: | |
Oh yeah, if the cones have sagged, newies will make a big difference. To raise the car 20mm the cones will only need to be 7mm higher.
|
|
| Author: | buztoy [ Sun Apr 22, 2007 9:08 pm ] |
| Post subject: | |
sweet as, i never thought of a washer, i was also thinking of welding a plate on the top of where the cone bounces on, thanks guys |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|