....cutting out shapes to weld into holes in a boot floor!
Are 850 doors a thicker gauge steel than later doors / panels? The ones I was chopping up today seemed to be.
| ausmini https://ausmini.com/forums/ |
|
| Rusty 850 doors are great for...... https://ausmini.com/forums/viewtopic.php?f=2&t=24178 |
Page 1 of 1 |
| Author: | GT [ Sat Oct 28, 2006 8:34 pm ] |
| Post subject: | Rusty 850 doors are great for...... |
....cutting out shapes to weld into holes in a boot floor!
Are 850 doors a thicker gauge steel than later doors / panels? The ones I was chopping up today seemed to be. |
|
| Author: | drmini in aust [ Sat Oct 28, 2006 8:41 pm ] |
| Post subject: | |
I dunno about the doors, but 850 floors were 1.6mm. Later floors seem thinner, and the Pommy repair panels are only 1mm. Old PC XT cabinets are not bad for boot floor panel work either. Later ones got thinner so not as good.
|
|
| Author: | GT [ Sat Oct 28, 2006 8:42 pm ] |
| Post subject: | |
drmini in aust wrote: the Pommy repair panels are only 1mm.
yea, and they feel like tissue paper. |
|
| Author: | JC [ Sat Oct 28, 2006 9:14 pm ] |
| Post subject: | |
Sacriledge!
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|