It works just slightly less effective. Oh, and I'd argue there are 4 types, standard with pressed steel impellor
, standard with cast impellor, high volume with bypass hose and also without 
| ausmini https://ausmini.com/forums/ |
|
| Water pumps https://ausmini.com/forums/viewtopic.php?f=2&t=24101 |
Page 1 of 1 |
| Author: | GT [ Thu Oct 26, 2006 9:40 pm ] |
| Post subject: | Water pumps |
There are 2 water pumps right? Standard and high volume? What happens if you run a standard on a 1275? |
|
| Author: | Anto [ Thu Oct 26, 2006 9:45 pm ] |
| Post subject: | |
It works just slightly less effective. Oh, and I'd argue there are 4 types, standard with pressed steel impellor , standard with cast impellor, high volume with bypass hose and also without
|
|
| Author: | Mick [ Thu Oct 26, 2006 9:45 pm ] |
| Post subject: | |
I was shocked recently after pulling my Cooper 1275 down for a mild refit that after ten years it had been running a standard pressed metal water pump....hmmm...I must have been a little short of cash at the time I can't remember...besides that it did a fantastic job and survived 6 years in Darwin then Victoria and Sydney and WA. The impeller was pitted but still it worked OK. It helps that the rest of the system was up to scratch as well though. I turfed it anyway to the spares bucket for a hi flow for good luck. |
|
| Author: | GT [ Thu Oct 26, 2006 9:48 pm ] |
| Post subject: | |
Thanks guys. 
Rebuilding my GT motor at the moment and I had a new spare standard water pump. Wasn't sure if it would be suitable. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|