I think the standard answer is a high flow pump the std pump does not move much water and the high flow pump will improve this usually idling is a problem because the pump is not going very fast and the flan is not providing much airflow.
| ausmini https://ausmini.com/forums/ |
|
| Normal or Hi-flow? need help/advice https://ausmini.com/forums/viewtopic.php?f=2&t=15635 |
Page 1 of 1 |
| Author: | =twista= [ Sun Jan 29, 2006 5:16 pm ] |
| Post subject: | Normal or Hi-flow? need help/advice |
Heya again fellas, im currently in the middle of a rebuild of my 1100 motor, and im wondering whether i should use a normal water pump or a hi-flow water pump? im really not sure what to use, what would be an advantage, or what would best suit my motor. Much help needed. thanks |
|
| Author: | fuzzy-hair-man [ Sun Jan 29, 2006 5:21 pm ] |
| Post subject: | |
I think the standard answer is a high flow pump the std pump does not move much water and the high flow pump will improve this usually idling is a problem because the pump is not going very fast and the flan is not providing much airflow.
|
|
| Author: | Hanra [ Sun Jan 29, 2006 6:26 pm ] |
| Post subject: | |
High capacity water pump simply uses a larger impeller, check clearance of impellar to block, as it protrudes in the water jacket further than a standard pump. |
|
| Author: | =twista= [ Sun Jan 29, 2006 7:08 pm ] |
| Post subject: | |
thanks |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|