cooperess wrote:
simon k Just to let you know, I used some BLUE TACK.
nice one!
| ausmini https://ausmini.com/forums/ |
|
| Bonnet Hinge Placement https://ausmini.com/forums/viewtopic.php?f=2&t=101502 |
Page 1 of 1 |
| Author: | cooperess [ Sat Aug 27, 2022 11:36 am ] |
| Post subject: | Bonnet Hinge Placement |
Attachment: Mini Bonnet Hinge (1).JPG What special grease is used to install washers so they don't drop out whilst trying to replace the hinge. |
|
| Author: | simon k [ Sat Aug 27, 2022 1:13 pm ] |
| Post subject: | Re: Bonnet Hinge Placement |
elbow! though a bit of yellow or white grease might do it - something that won't be too ugly on the paint as it comes out maybe I've held the washers and the hinge together and slipped all three in to place at the same time? not sure I've ever used grease or anything to help, it's probably just one of those crappy jobs where you've gotta hold your tongue right and then when you wiggle your left big toe it slips into place |
|
| Author: | OGW1152 [ Sat Aug 27, 2022 3:16 pm ] |
| Post subject: | Re: Bonnet Hinge Placement |
When I've run out of patience in the past, one drop of super glue to cleaned surfaces did the job. Glen |
|
| Author: | simon k [ Sat Aug 27, 2022 10:38 pm ] |
| Post subject: | Re: Bonnet Hinge Placement |
OGW1152 wrote: When I've run out of patience in the past, one drop of super glue to cleaned surfaces did the job. Glen that would definitely cure the frustration - "stay put you bastard!" |
|
| Author: | cooperess [ Sat Aug 27, 2022 11:30 pm ] |
| Post subject: | Re: Bonnet Hinge Placement |
simon k Just to let you know, I used some BLUE TACK. |
|
| Author: | simon k [ Sat Aug 27, 2022 11:43 pm ] |
| Post subject: | Re: Bonnet Hinge Placement |
cooperess wrote: simon k Just to let you know, I used some BLUE TACK. nice one!
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|