Hi All,
Is there a definite orientation to fit the hex bush in relation to the three machined areas on the rack housing? Corners aiming at the cutouts on the rack or flat edges?
| ausmini https://ausmini.com/forums/ |
|
| Steering Rack Bush https://ausmini.com/forums/viewtopic.php?f=2&t=101112 |
Page 1 of 1 |
| Author: | timmy201 [ Fri Aug 20, 2021 7:26 pm ] |
| Post subject: | Steering Rack Bush |
Hi All, Is there a definite orientation to fit the hex bush in relation to the three machined areas on the rack housing? Corners aiming at the cutouts on the rack or flat edges?
|
|
| Author: | drmini in aust [ Fri Aug 20, 2021 8:16 pm ] |
| Post subject: | Re: Steering Rack Bush |
I line up the flats with the metal bits. Unless the shaft has been gouged by the grubscrew, then I turn the bush just enough to miss it |
|
| Author: | timmy201 [ Sat Aug 21, 2021 5:35 am ] |
| Post subject: | Re: Steering Rack Bush |
Thanks Kev. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|