Ha ha. Great post title.
Also one of the better movies I've seen. Pure Kiwi droll humour, led by the amazing Sam Neill and backed up by the fat kid.
"No child left behind"
Attachment:
81-hunt-for-the-wilderpeople.jpg
| ausmini https://ausmini.com/forums/ |
|
| Hunt for the Welderpeople https://ausmini.com/forums/viewtopic.php?f=2&t=101058 |
Page 1 of 1 |
| Author: | cush [ Fri Jul 16, 2021 8:57 pm ] |
| Post subject: | Hunt for the Welderpeople |
Ahoy, What's the "best" first welder to get for putting smaller bits of a mini onto a bigger bit of a mini? |
|
| Author: | MiniPete [ Fri Jul 16, 2021 9:23 pm ] |
| Post subject: | Re: Hunt for the Welderpeople |
There will be a plethora of opinions here. I have a unimig Viper 185 and it is amazing. Mine is a bout 8 yo now has not missed a beat and upon graduating from the old SIP Migmate, it moved my welds from Zero to hero. I think every garage should have a good mig. |
|
| Author: | Shaunsyd [ Fri Jul 16, 2021 11:38 pm ] |
| Post subject: | Re: Hunt for the Welderpeople |
I have a unimig 182 which is the largest welder in the range on a 10 amp plug it's never missed a beat I'm very happy with it |
|
| Author: | MiniPete [ Sat Jul 17, 2021 8:58 am ] |
| Post subject: | Re: Hunt for the Welderpeople |
Hard to Fault Unimig. I had a garage flood a couple of years ago when I was still in Melbourne, my welder was completely submerged. I pulled the cover off, dried with compressed air then gave it a couple of months to dry out, took it to work and plugged it in (didn't want to burn my own place down!). I'd written it off but nope, she's still working perfectly. |
|
| Author: | winabbey [ Sat Jul 17, 2021 9:56 am ] |
| Post subject: | Re: Hunt for the Welderpeople |
Ha ha. Great post title. Also one of the better movies I've seen. Pure Kiwi droll humour, led by the amazing Sam Neill and backed up by the fat kid. "No child left behind" Attachment: 81-hunt-for-the-wilderpeople.jpg
|
|
| Author: | winabbey [ Sat Jul 17, 2021 9:58 am ] |
| Post subject: | Re: Hunt for the Welderpeople |
I see Unimig Australia offer a free guide to MIG welding. https://unimig.com.au/ |
|
| Author: | iansmini67 [ Sat Jul 17, 2021 8:29 pm ] |
| Post subject: | Re: Hunt for the Welderpeople |
I just bought a CIG Weldskill 185 from Sydney Tools for around $800. Its a three in one unit so at a later stage you can do Tig wleding. I have also had great success with welding Alloy with it. Cheers Ian |
|
| Author: | 68+86auto [ Mon Jul 19, 2021 9:31 pm ] |
| Post subject: | Re: Hunt for the Welderpeople |
Make sure the minimum mig current is 30a or below unless it has a spot timer. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|