ausmini
https://ausmini.com/forums/

Shrader Valve -hydrolastic
https://ausmini.com/forums/viewtopic.php?f=2&t=101051		 Page 1 of 1
Author:  crisonic [ Tue Jul 13, 2021 11:06 pm ]
Post subject:  Shrader Valve -hydrolastic
Does anybody know the thread size of the valve where it mounts onto the hydro connector?
Author:  gtogreen1969 [ Tue Jul 13, 2021 11:52 pm ]
Post subject:  Re: Shrader Valve -hydrolastic
crisonic wrote:
Does anybody know the thread size of the valve where it mounts onto the hydro connector?


External thread on a tyre valve is 0.305 inches (7.7mm) and 32 threads per inch
Author:  crisonic [ Wed Jul 14, 2021 11:54 am ]
Post subject:  Re: Shrader Valve -hydrolastic
Thank you for the info but it is the thread on the other end of the valve that screws into the pipe connector that I am after. Anybody know what it is?
Author:  gtogreen1969 [ Wed Jul 14, 2021 3:21 pm ]
Post subject:  Re: Shrader Valve -hydrolastic
crisonic wrote:
Thank you for the info but it is the thread on the other end of the valve that screws into the pipe connector that I am after. Anybody know what it is?

No sorry I don't.
Author:  drmini in aust [ Wed Jul 14, 2021 3:28 pm ]
Post subject:  Re: Shrader Valve -hydrolastic
I made a fitting for my hydro pump by soldering a drilled brass valve cap into a BSP brass nipple. It's still working, 30 years later.
I use an O ring inside the cap to seal.
Author:  Bill B [ Wed Jul 14, 2021 4:05 pm ]
Post subject:  Re: Shrader Valve -hydrolastic
Attachment:
Schrader valve and Union.jpg

Do you mean this thread on the schrader valve to hydro union?

If so, it is 1/8 inch BSPT (tapered). Same thread as the brass drain plug from my mini K original radiator, next to valve in photo.
Author:  crisonic [ Wed Jul 14, 2021 11:02 pm ]
Post subject:  Re: Shrader Valve -hydrolastic
Thank you Bill.That is the thread details I wanted. Thank you to everyone who replied
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/