Hey Turbo. I didn't measure mine exactly but the non technical term would be a whisker or perhaps a tad
If I had to guess at a measurement, I'd say about 0.5mm. Press them in just enough so that they are just inside the housing.
Cheers Rocky
| ausmini https://ausmini.com/forums/ |
|
| Upper suspension arm https://ausmini.com/forums/viewtopic.php?f=2&t=100820 |
Page 1 of 1 |
| Author: | Turbo_squarenose [ Mon Mar 08, 2021 11:25 am ] |
| Post subject: | Upper suspension arm |
When replacing the bearings, how far in from the outside edges of the arm should the bearing be? Been that long since I stripped them I can’t recall. Cheers |
|
| Author: | rocky&bullwinkle [ Tue Mar 09, 2021 2:57 pm ] |
| Post subject: | Re: Upper suspension arm |
Hey Turbo. I didn't measure mine exactly but the non technical term would be a whisker or perhaps a tad If I had to guess at a measurement, I'd say about 0.5mm. Press them in just enough so that they are just inside the housing. Cheers Rocky |
|
| Author: | Bill B [ Tue Mar 09, 2021 3:29 pm ] |
| Post subject: | Re: Upper suspension arm |
Hey! This is a moment. Rocky has gone from asking advice to helping someone with advise. This is great to see. We have all gone through a similar process of learning about minis and then helping where we can. And, for what it's worth, I agree with Rocky's comment. |
|
| Author: | drmini in aust [ Tue Mar 09, 2021 3:31 pm ] |
| Post subject: | Re: Upper suspension arm |
I agree with rocky ^^ Just below flush. If you push them right in a puller won't get them out. There's blog I put in the how-to forum on making a puller, which will also pull the idler gear bearing out of the flywheel housing. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|