Hi guys, trying to id som parts i got in a job lot. Looks like a couple of clutch bearings? But all the black seals are beyond me. The three big bits I'm not sure are mini at all... Any help is great.
Sent from my SM-A515F using Tapatalk
| ausmini https://ausmini.com/forums/ |
|
| Parts ID https://ausmini.com/forums/viewtopic.php?f=2&t=100718 |
Page 1 of 1 |
| Author: | bluehishouse [ Thu Jan 28, 2021 3:23 pm ] |
| Post subject: | Parts ID |
Hi guys, trying to id som parts i got in a job lot. Looks like a couple of clutch bearings? But all the black seals are beyond me. The three big bits I'm not sure are mini at all... Any help is great. Sent from my SM-A515F using Tapatalk |
|
| Author: | cooperess [ Thu Jan 28, 2021 3:34 pm ] |
| Post subject: | Re: Parts ID |
One looks like a water pump seal. |
|
| Author: | 1071 S [ Thu Jan 28, 2021 3:40 pm ] |
| Post subject: | Re: Parts ID |
Couple of clutch throwout bearings, couple of brake/clutch master or slave seals, a wheel bearing seal???? Cheers, Ian |
|
| Author: | bluehishouse [ Thu Jan 28, 2021 4:54 pm ] |
| Post subject: | Re: Parts ID |
Ooh is one a diff output seal? Sent from my SM-A515F using Tapatalk |
|
| Author: | Andosoft [ Thu Jan 28, 2021 5:04 pm ] |
| Post subject: | Re: Parts ID |
timing cover ? |
|
| Author: | Scoop [ Sat Feb 06, 2021 8:03 pm ] |
| Post subject: | Re: Parts ID |
Flat metal bit with 3 slots is of the clutch diaphragm, throw out bearing runs on it. Metal bit with 5 lugs is a lock tab for front wheel bearings of a Landcruiser or similar. Long flat metal thing with markings, 6 inch metal rule!!! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|