Is this harmonic balancer suitable for a 1275.
Is the rubber insert too far gone
Attachment:
F0AEF366-5685-4335-9087-0FC02DDA0938.jpeg
Attachment:
52247FAA-483A-4B0A-899D-A51B7546F24F.jpeg
| ausmini https://ausmini.com/forums/ |
|
| Harmonic balancer https://ausmini.com/forums/viewtopic.php?f=2&t=100463 |
Page 1 of 1 |
| Author: | Phil 850 [ Tue Oct 13, 2020 8:02 pm ] |
| Post subject: | Harmonic balancer |
Is this harmonic balancer suitable for a 1275. Is the rubber insert too far gone Attachment: F0AEF366-5685-4335-9087-0FC02DDA0938.jpeg Attachment: 52247FAA-483A-4B0A-899D-A51B7546F24F.jpeg
|
|
| Author: | drmini in aust [ Wed Oct 14, 2020 4:15 am ] |
| Post subject: | Re: Harmonic balancer |
Run a razor blade along to trim it off flush. If no crack showing then it's ok. |
|
| Author: | Phil 850 [ Fri Oct 16, 2020 7:18 pm ] |
| Post subject: | Re: Harmonic balancer |
As advised, I trimmed the rubber back and there are no signs of cracks. Must have been surface cracks due to ozone/surface tension. Attachment: A04D1D64-0A34-4FC1-A846-9D787419465A.jpeg
|
|
| Author: | diecast [ Sun Oct 18, 2020 8:28 pm ] |
| Post subject: | Re: Harmonic balancer |
Nice work |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|