| ausmini https://ausmini.com/forums/ |
|
| Mk1 Bonnet Badge Hole Positions https://ausmini.com/forums/viewtopic.php?f=2&t=100146 |
Page 1 of 1 |
| Author: | TDS76 [ Mon Jun 29, 2020 2:26 pm ] |
| Post subject: | Mk1 Bonnet Badge Hole Positions |
Hi, Does anyone have an original bonnet that they can measure the hole positions for me for the Mk1 badge as fitted to 850s etc? I have searched this, the Mk1 forum and TMF and can find nothing definitive for the Morris bonnet - plenty on the Morris boots and Austin bonnets, but nothing that helps. I have positioned this template 2" up from the leading edge of the bonnet but this looks a bit high to me. Cheers, Paul. Attachment: IMG_2063.jpg
|
|
| Author: | rocky&bullwinkle [ Mon Jun 29, 2020 6:25 pm ] |
| Post subject: | Re: Mk1 Bonnet Badge Hole Positions |
G'day Paul, Can take some measurements tomorrow as my bonnet is at the panel shop and getting primed ready for paint tonight. Mine is a 1963 850 - is that what you're chasing? As a matter of interest, what colour is that? Cheers, Rocky |
|
| Author: | rocky&bullwinkle [ Tue Jun 30, 2020 1:32 pm ] |
| Post subject: | Re: Mk1 Bonnet Badge Hole Positions |
Paul, Holes are 1" 13/16ths or 46mm from edge of bonnet to centre of holes. Rocky |
|
| Author: | TDS76 [ Tue Jun 30, 2020 8:19 pm ] |
| Post subject: | Re: Mk1 Bonnet Badge Hole Positions |
Thanks Rocky, exactly what I was after. Not sure what the green is (maybe Tamarisk) - it was this colour when I bought it, original colour was Crystal white. Cheers, Paul |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|