Hi don't know if this is the right section for this
I recently purchased a hydrolastic pump it works but leaks a bit from the pump seals and the vacuum side is missing the fitting off the end and gauge isn't working
can parts be sourced for these? as I'd like to restore it/tidy it up
any help would be great even what colour it should be
thanks

Where do you find this stuff mitch?

_________________
The best part of fixing your mini is the test drive

Minis..

1976 van daily drive
1975 van
1968 deluxe in the shed
1967 deluxe high strung 1310
1959 austin healey sprite

Bought that from a guy off gumtree recently im guessing, I rang him he told me people were calling from all over the country offering more than what he was asking

_________________
1965 Riley Elf
1974 Ex Army Moke
1997 Rover Cooper
2002 JCW Cooper
2003 JCW Cooper S

the guage can be repaired usually, the 'end' you refer to I asume is the hose end?, just an old tyre valve chuck. Our 'original' one was sort of light green hammer tone.

Yes it's the one that was on Gumtree
Thanks Peter what about the seals in the actual pump(like the ram) can you get them?

I've never actually had one apart but if BMC is associated with it, it won't be too tricky, more than likely rusty in bore/ram. Rip it apart and have a look, probably o rings or similar.

morris 1100 is the expert on these pumps...

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

Mine is black

_________________
1969 Cooper "S"
1967 Mini Deluxe
1973 Clubman Van (the fleet spare)
1978 ex 1275 LS ("Wizard" Eaton Supercharged)
2015 HSV GenF GTS(occasional drive & tow car)
2019 MINI F55 Cooper S

First, the good news. Below is a BMC Technical Bulletin that might help you understand how the pump works.

Now, the bad news. The repair kits are no longer available.

But some more good news. As stated, Morris 1100 on here has refurbished these so could help you locate the component parts.

Also, I can give you the name of someone else who has overhauled several so may also be of help. Just PM me.

_________________
ex-NSW Police 1970 MK II Cooper S
VMCI #43

Getting to the finishing stages of the rebuild of this pump. I got some seals made up for the pressure side(the left side)they couldn't make them to the original ones, they used poly bush however it still leaks a bit
So my question is has anyone got some make up that work? If so where from any help would be great
Thanks Mitch

PM 850man and Morris 1100 on here as they have both refurbished these pumps. 850man also sells repro instruction plates that screw to the top.

_________________
ex-NSW Police 1970 MK II Cooper S
VMCI #43

Mitch its no good mate, has a fly on it so must be buggered. As im such a nice bloke I'll take it off your hands and save you the hassles. Im good like that.

_________________
1965 Riley Elf
1974 Ex Army Moke
1997 Rover Cooper
2002 JCW Cooper
2003 JCW Cooper S

I have a new plate to go on the top pretty sure I got it from him
Jason it has been a lot messing around for this thing trying to get lines and fittings I'll be happy once its done!